RTL8777G Dongle Evaluation Board

Overview

The RTL8777G dongle evaluation board provides a hardware environment for user development, including:

5V to 3.3V power module

Antenna module

LED module

Reset key and four independent keys

USB to UART chip, FT232RL

Blocks Distribution

The following introduces the main blocks on the evaluation board in counterclockwise order.

Introduction of the main blocks on the dongle evaluation board
Blocks	Introduction
Reset Key	Pressing this key resets the system
Independent Keys	The keys SW1, SW2, SW3 and SW4 are connected to P9_1, P9_0, P4_3 and P4_2 respectively
UART/LOG Test Interface	Supports download mode and normal mode
USB to UART Chip	FT232RL USB to UART chip for downloading programs or debug
USB Port CON1	Used to power the EVB and connect FT232RL USB to UART chip for downloading programs or debug
USB Port J1	Used to power EVB and communicate with RTL8777G via USB
LDO Chip	AMS117-3V3 LDO chip converts a 5V input voltage into a stable 3.3V output voltage
LED module	Provides three LEDs
RTL8777G	RTL8777G is an ultra-low power wireless microcontroller that supports Bluetooth 5.3/Zigbee/Thread/Master protocols
IPEX Socket	Used for external antenna
ANT	Ceramic antenna

Interfaces Distribution

Blocks and Interfaces Introduction

LED module: LED module can be connected to the pin header within the red box through jumpers, allowing the default GPIO to control the LED. Alternatively, you can use Dupont wires to connect the pin header on the left side of the red box to any GPIO for controlling the LED.

../../../_images/Dongle_LED.jpg — Dongle EVB LED module

IPEX Socket: The IPEX socket holder is used for external antenna. When using an external antenna, it is necessary to remove capacitor C16 and then place capacitor C33.

../../../_images/Dongle_IPEX.jpg — Dongle EVB IPEX Socket

EVB User Guide

EVB Power Connection

The dongle EVB can be powered by USB port CON1 or USB port J1:

Use USB port CON1 for power supply, and connect the jumper marked in red.

../../../_images/Dongle_CON1.png — Use USB port CON1 for power supply

Use USB port J1 for power supply, and connect the jumper marked in red.

../../../_images/Dongle_J1.png — Use USB port J1 for power supply

Download Mode Connection

P0_3 (log) is the download mode selection pin. When P0_3 is pulled low, performing a hardware reset or power cycling will put the system into download mode. Use USB port CON1 for power supply. Use jumpers to connect P3_0 to RX and P3_1 to TX, pull low P0_3. Then power on the board or press the reset button to enter download mode.

../../../_images/Dongle_download_mode.png — Dongle EVB download mode connection

Normal Mode Connection

Use USB port CON1 for power supply. Connect the pin headers marked in the red box using jumpers to connect P0_3 to RX. Then power on the board or press the reset button and start running the program. Use the Debug Analyzer for debug.

../../../_images/Dongle_normal_mode.png — Dongle EVB normal mode connection